ANY ONE OTHER THAN PSC make cornners?

[Bult4mud]

kinda dented the rear of my tub so it sounds like its time for some crusher type corners but i dont really want to cover the whole side just the corners

BEFORE ANY ONE SAYS ANYTHING IM NOT COMP CUTTING IT

just wondered if any one had some ideas

[WhiteRhino]

Yeah, why don't you comp cut it? :rolf: :rolf:

[Kixx007]

Time to make it a buggy.

[mitrail400ex]

<div class='quotetop'>QUOTE(Kixx007 &#064; Mar 22 2006, 04&#58;06 PM) 12284</div>

Time to make it a buggy.
[/b]
What did I tell you would happen the next time you said the "b" word??? Watch your back, sonny.... :ph34r:


Jim...I think this is an excellent opportunity to show off your fab skillz. 3/16" steel should bend FAIRLY easy over a nice template when heated. I think you could make something for WAY cheaper than anyone would sell it for.

[Bult4mud]

<div class='quotetop'>QUOTE(mitrail400ex &#064; Mar 22 2006, 02&#58;17 PM) 12287</div>

<div class='quotetop'>QUOTE(Kixx007 &#064; Mar 22 2006, 04&#58;06 PM) 12284

Time to make it a buggy.
[/b]
What did I tell you would happen the next time you said the "b" word??? Watch your back, sonny.... :ph34r:


Jim...I think this is an excellent opportunity to show off your fab skillz. 3/16" steel should bend FAIRLY easy over a nice template when heated. I think you could make something for WAY cheaper than anyone would sell it for.
[/b][/quote]


well i respect your enthusiasm eric anyone who knows me and has seen my fab skillz may disagree

i think its 130 for the psc trail corners

[Deathdealer]

Here are some more that i could find.

http://www.rokmen.com/swb_corners.html

http://www.quadratec.com/products/12525_502.htm